| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Anyone heard of PC Rot Terminator??? http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=14098 |
Page 1 of 1 |
| Author: | s30series [ Wed Aug 26, 2009 4:58 pm ] |
| Post subject: | Anyone heard of PC Rot Terminator??? |
Can't find Get-Rot for the life of me around Marietta....i did find the PC Rot Terminator kit at ACE hardware for $26......says its good for delmanination of fiberglass.... anyone used it before??? Bueller? Bueller? |
|
| Author: | Maximus [ Wed Aug 26, 2009 5:22 pm ] |
| Post subject: | Re: Anyone heard of PC Rot Terminator??? |
Haven't heard of PC Rot, but here's a heads up;I ordered some Git Rot (32oz) through Ebay and with shipping it came to about $60; a substantial savings over West Marine or anywhere else. |
|
| Author: | s30series [ Wed Aug 26, 2009 5:27 pm ] |
| Post subject: | Re: Anyone heard of PC Rot Terminator??? |
huh. didnt know west marine sold it..... this is 24oz for $26, and its exaclty the same thing as get-rot (as far as i can tell) wonder if the chemical makeup is the same??? hmmmmmmmmmmmmm |
|
| Author: | Maximus [ Thu Aug 27, 2009 6:06 pm ] |
| Post subject: | Re: Anyone heard of PC Rot Terminator??? |
Ya, West Marine sells it on their web site. I was wondering about the chemical makeup too. I have to say that with all of the delamination issues on these boats, and all of the different products out there for fixing them, I've never heard anyone say what they used didn't work. No one ever says, "don't use ____!". One thing I've heard Git Rot has going for it is that it is pre-thined, so it's easier to get it where it needs to go. I'm doing mine tomorrow... wish my luck! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|