Just came in today....after looking at it, it looks bent!
Supposed to be like that?!?!?
it looks like the cam plate is twisted off to one side...is it supposed to be like that?
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Just got brand new Harken gear...is it bent??? http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=14365 |
Page 1 of 1 |
| Author: | s30series [ Wed Sep 02, 2009 5:32 pm ] |
| Post subject: | Just got brand new Harken gear...is it bent??? |
Just came in today....after looking at it, it looks bent! Supposed to be like that?!?!? it looks like the cam plate is twisted off to one side...is it supposed to be like that? |
|
| Author: | sharkfeed2000 [ Wed Sep 02, 2009 6:11 pm ] |
| Post subject: | Re: Just got brand new Harken gear...is it bent??? |
doesnt look bent,try adjusting it or take it back to your dealer |
|
| Author: | Tri_X_Troll [ Mon Sep 07, 2009 5:51 pm ] |
| Post subject: | Re: Just got brand new Harken gear...is it bent??? |
It could be slightly out of adjustment on one side? if you turn it sideways you should see two screws that allow you to adjust the angle of the cam. Perhaps one is loose and the assembly is shifted. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|