| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| rudders http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=24467 |
Page 1 of 1 |
| Author: | Bean [ Wed May 12, 2010 4:32 pm ] |
| Post subject: | rudders |
I have new EPO carbon rudders. Any tricks to drilling them? Do I just need to use my originals as templates? |
|
| Author: | srm [ Wed May 12, 2010 5:20 pm ] |
| Post subject: | Re: rudders |
Use a drill press if possible in order to keep the holes perpendicular to the rudder surface. Also, place a block of scrap wood under the rudder hole locations when drilling so you don't split out or chip the bottom of the holes. sm |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|