| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Need instructions for rigging an aussie jib setup http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=24893 |
Page 1 of 1 |
| Author: | jsloan999 [ Tue May 18, 2010 8:50 pm ] |
| Post subject: | Need instructions for rigging an aussie jib setup |
How do you rig an aussie setup? I assume I should shackle the lower end of the jib first, but what are the tricks to keep me from ending up with a tangled mess? Thanks - |
|
| Author: | Tallguy1 [ Wed May 19, 2010 5:17 am ] |
| Post subject: | Re: Need instructions for rigging an aussie jib setup |
There's no real tricks, I keep my halyard down at the bottom of the mast while setting up, then when hooking up the jib, just make sure the blocks are lined up at the top and bottom ortherwise it may get twisted as you crank up the jib. Then take all the extra line after cleating it off and wrap it up in neat loops and stash it on the deck, on the tramp pocket if you have one. Hope that helps! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|