| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Jib block question http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=25911 |
Page 1 of 1 |
| Author: | branson [ Fri Jun 04, 2010 1:28 am ] |
| Post subject: | Jib block question |
Does anyone know if you can replace the jib blocks of an H16 with those of an H18? The numbers in the parts catalog do not match up, and I am not concerned with being race legal. |
|
| Author: | srm [ Fri Jun 04, 2010 10:56 am ] |
| Post subject: | Re: Jib block question |
Which blocks? The turning blocks that shackle to the clew plate on the jib, yes. The blocks with the cleat that mount to the front crossbar, no. Well, I guess theoretically you could use them, but it would work very poorly. The stack-up is way too high and the block would flop all over the place making uncleating very difficult. sm |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|