| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Where is the drink holder accessory? http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=31039 |
Page 1 of 1 |
| Author: | ET Hobie guy [ Sat Sep 04, 2010 6:32 pm ] |
| Post subject: | Where is the drink holder accessory? |
Page 22 of the Hobie Accessory catalog shows a picture of an "Accessory Mounting Plate" part #1161/62 (which I have on my 16). The caption below the photo reads: "Universal mounting plate for swivel cam cleats, compasses, drink holders, etc. High strength black Delrin® construction that is ultraviolet tolerant." I am curious about the drink holders. They are obviously not in the catalog, unless I am blind. Are these still available or not? |
|
| Author: | Hammond [ Mon Sep 06, 2010 8:36 pm ] |
| Post subject: | Re: Where is the drink holder accessory? |
Use a foam beer can "coozie". Cut it in half so you can grab the beer. there is usually a hole in the bottom of the foam, find a big stainless fender washer and a sheet metal screw. Attach the "coozie" on the corner casting with the screw and big washer. |
|
| Author: | ET Hobie guy [ Tue Sep 07, 2010 6:49 pm ] |
| Post subject: | Re: Where is the drink holder accessory? |
I've done something similar to that except cut the coozie down. I made large washers out of stiff plastic, put them in the coozies and zip tied them to the "accessory mounting plate". Works OK. I was just wondering what the drink holder accessory looked like and how it attached. Thanks |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|