| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Pylon & casting bolt holes misalligned http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=3213 |
Page 1 of 1 |
| Author: | rkemme [ Wed Mar 22, 2006 9:15 pm ] |
| Post subject: | Pylon & casting bolt holes misalligned |
I've just recently exchanged both hulls on a Hobie 16. But when the tramp frame was reattached, one corner casting is near impossible to mount on it's pylon, and the other three had missalligned holes. I really don't want to go back to the old hulls. Can I simply bore new (maybe bigger) holes through both pylon and casting and be done with bigger bolts (or maybe washers)? Or is there a better way? I suspect that the older hulls are some 5-6 yrs older than the '82 hulls I'm converting to. Did Hobie change the hole pattern over the years? Aside from a tramp adjustment, any ideas on how I can get the holes to line up? Thanks, in advance. Ralph |
|
| Author: | Hobie Nick [ Thu Mar 23, 2006 6:40 am ] |
| Post subject: | |
If the tramp is still in the frame I would remove the tramp, attach the frame then reinstall the tramp. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|