| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| H16/H14 rudders http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=33918 |
Page 1 of 1 |
| Author: | sunvista [ Wed Feb 09, 2011 6:46 am ] |
| Post subject: | H16/H14 rudders |
Is there any difference between the Hobie 16 and 14 Turbo rudder blades? Composition and/or bolt hole template? |
|
| Author: | sunjammers [ Wed Feb 09, 2011 6:54 am ] |
| Post subject: | Re: H16/H14 rudders |
There have been several variations of the rudder blades over the years. I do not think there were any specific differences in years past with the blades supplied with H14's and H16's. The Bolt patterns are then same. |
|
| Author: | MBounds [ Wed Feb 09, 2011 7:37 am ] |
| Post subject: | Re: H16/H14 rudders |
sunvista wrote: Is there any difference between the Hobie 16 and 14 Turbo rudder blades? Composition and/or bolt hole template? As Brad mentioned, there have been several composition changes over the years, but of boats of the same vintage, there should be no difference. The bolt hole pattern is slightly different for rake adjustable castings (1983 & newer) than the original, non rake adjustable castings. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|