You mean like this?
1-3/8" inside edge to inside edge, 1-3/4" outside edge to outside edge.
I guarantee your mast step doesn't look like that unless your boat is less than 10 years old.
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| H16 Mast step. Measurement of stops? http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=34495 |
Page 1 of 1 |
| Author: | nc_native [ Sat Mar 19, 2011 11:58 am ] |
| Post subject: | H16 Mast step. Measurement of stops? |
I'm checking the wear of the stops on the base. Can someone take a measurement of a new base, stop to stop, at the widest point to give a reference to my old one? A plan view perspective, looking down on it, would work. |
|
| Author: | MBounds [ Sat Mar 19, 2011 2:08 pm ] |
| Post subject: | Re: H16 Mast step. Measurement of stops? |
You mean like this? 1-3/8" inside edge to inside edge, 1-3/4" outside edge to outside edge. I guarantee your mast step doesn't look like that unless your boat is less than 10 years old. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|