Hobie Forums http://www.hobie.com/au/en/forums/
h16 rudders http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=35238	Page 1 of 1

---

Author:	bigrooster [ Thu Apr 28, 2011 8:02 pm ]
Post subject:	h16 rudders
Where can Iget a rudder template for h16

---

Author:	56kz2slow [ Fri Apr 29, 2011 4:00 am ]
Post subject:	Re: h16 rudders
at the top of this page, click on "Support" on the left column, under "Product Support", click on "Sailboats" in the "REPAIR" section, click on "Rudders - Cams / Rake / Alignment" In there, you will find the instructions and also a link to the template.

---

Author:	MBounds [ Fri Apr 29, 2011 4:01 am ]
Post subject:	Re: h16 rudders
Contact David Brookes at the IHCA - david.brookes(at)hobieclass.com

---

Author:	sunvista [ Fri Apr 29, 2011 6:05 am ]
Post subject:	Re: h16 rudders
Before you print it make sure you turn off all scaling in your printer properties. It usually says something like "shrink to print" or "fit to page". After you print it measure the two dimensions for accuracy. Also try to find some heavy bond to print it on.

---

Page 1 of 1	All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/