| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Covering up soft spot repair holes http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=36236 |
Page 1 of 1 |
| Author: | PurdueZach [ Thu Jun 16, 2011 3:44 pm ] |
| Post subject: | Covering up soft spot repair holes |
I just finished doing the West Systems epoxy repair of some soft spots on my hulls. How did you guys hide the holes? I am kind of a neat freak so I like everything to look good. I tried gelcoat putty but when I sanded it flat, it just took it all off and I was back where I started. I'm looking for something other than re-gelcoating or painting. |
|
| Author: | annacat [ Fri Jun 17, 2011 12:19 am ] |
| Post subject: | Re: Covering up soft spot repair holes |
This was how I did it for some missing gel.. props to Jeremy from Surf City Racing for the advice. I am 100% happy with the outcome. Sorry about the music.. it seemed better than listening to a grinder for 3 minutes & the choices were limited. [youtube]http://www.youtube.com/watch?v=qwrjmyBR7c8[/youtube] |
|
| Author: | IturbeR [ Mon Jun 27, 2011 1:00 pm ] |
| Post subject: | Re: Covering up soft spot repair holes |
That was an acurate video for your issue, but remember that every epoxy or polyester resin have different amounts of catalyst. BTW, if you've never seen what happends when there is a lot of catalyst with very smalls amounts of resin, do it. It'll be fun to see. Saludos desde Veracruz Greetings form Veracruz |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|