Last time out on the water I noticed the port-stern corner weld on the mesh has separated, Any way to fix this before I have major problems ?
Thanx in advance
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Mesh tramp de-lamination Question http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=36292 |
Page 1 of 1 |
| Author: | buck [ Mon Jun 20, 2011 5:16 am ] |
| Post subject: | Mesh tramp de-lamination Question |
Last time out on the water I noticed the port-stern corner weld on the mesh has separated, Any way to fix this before I have major problems ? Thanx in advance |
|
| Author: | mmiller [ Mon Jun 20, 2011 11:54 am ] |
| Post subject: | Re: Mesh tramp de-lamination Question |
An upholstery shop can sew a repair. No way to glue or heat weld repairs. |
|
| Author: | buck [ Mon Jun 20, 2011 1:21 pm ] |
| Post subject: | Re: Mesh tramp de-lamination Question |
Thanx Matt , That was going to be the next thing I tried. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|