I was prepping the boat for a run today and notice some little splits/cracks right up in the crease under the outer lip on the starboard hull, just around the shroud anchor. They extend about 8" foreward and maybe 2-3" aft.
They don't appear to open up when I pull on them, but I can't apply the same amount of pressure as the shroud would in a good breeze.
They are matching hull #'s and the port hull is fine in this area.
After a bit more of a look around, I noticed similar marks toward the bow on both hulls. They start about 6 inches back from the bow tangs and go for about 2 feet. Again, they don't look like they will open up any time soon, but after reading about SplashTX's woes where he lifted a section and had to trash the hull, I don't want to find out the hard way.
Any ideas???
I can post photos later, but it's dark outside right now....
...and I'm scared of the dark.
....
