| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| shroud adjuster covers http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=38124 |
Page 1 of 1 |
| Author: | brstsmith [ Tue Aug 30, 2011 2:34 pm ] |
| Post subject: | shroud adjuster covers |
Can new shroud adjuster covers slide over on a shroud wire without removing the end fitting ?? I am finding 8" and 12" covers available , which are preferred ? Thanks,Steve |
|
| Author: | mmiller [ Tue Aug 30, 2011 2:45 pm ] |
| Post subject: | Re: shroud adjuster covers |
Yes, they push on over the thimble. We have only offered 12" boots. #3261B (Black). |
|
| Author: | MBounds [ Tue Aug 30, 2011 6:17 pm ] |
| Post subject: | Re: shroud adjuster covers |
1) The boots are easily trimmed to length with scissors. 2) It's a lot easier to work the boot over the thimble when the boot's warm (put it in the sun for a few minutes). |
|
| Author: | brstsmith [ Tue Aug 30, 2011 10:59 pm ] |
| Post subject: | Re: shroud adjuster covers |
MBounds wrote: 1) The boots are easily trimmed to length with scissors. 2) It's a lot easier to work the boot over the thimble when the boot's warm (put it in the sun for a few minutes). Ahh.. yea on the warmth..thanks for the info.. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|