| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Hobie "Bob" installation http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=3982 |
Page 1 of 1 |
| Author: | tomhuntington [ Sat Jun 24, 2006 6:37 pm ] |
| Post subject: | Hobie "Bob" installation |
Hey guys, I'm new to this forum and a fairly new hobie owner. My hobie has the single pulley style masthead, and I just bought a hobie "baby bob" float for it. I couldn't figure out how install it, and I thought that you had to have a dual pulley masthead for it, so i bought a used one for $45, but I still don't know how to install it. I don't even know what a comptip is! Any help would be appreciated. |
|
| Author: | mmiller [ Sun Jun 25, 2006 10:42 am ] |
| Post subject: | Instructions |
The 30116 instruction sheet explains it... http://static.hobiecat.com/2010_archive/support/pdfs/30116.pdf |
|
| Author: | yoh [ Sun Jun 25, 2006 1:18 pm ] |
| Post subject: | |
On a comptip equiped mast the last (six or so) feet of mast are made from a composit material (glassfiber and epoxy) - Comptip Your mast has no comptip - you mentioned that you have a single pully on the mast tip. You might have to drill a hole in the bracket of the bob to bolt through the center of the tip. Patrick |
|
| Author: | mmiller [ Mon Jun 26, 2006 9:50 am ] |
| Post subject: | Attach |
The baby bob attaches with 4 screws into the original cast aluminum head. Short self taping screws as explained in the instructions (link posted above). |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|