Hobie Forums
http://www.hobie.com/au/en/forums/

Need an inspection port lid for my Hobie 16, 5" port
http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=42566		 Page 1 of 1
Author:  Fxloop [ Mon May 07, 2012 10:21 am ]
Post subject:  Need an inspection port lid for my Hobie 16, 5" port
Someone apparently needed one of mine more than me..... :roll: they we're very tight and took a little red knuckles to unscrew so i'm sure it didn't " fall out " while trailering. I'f any of you guys have a spare or a set to sell i'm ready to buy. I can't sail until i get one as its on the rear of the starboard hull and will full with water lol.
The port is 5" but the lid is roughly about 4 3/4" .....thanks guys!
Tim

[email protected]
Author:  Jbernier [ Mon May 07, 2012 10:54 am ]
Post subject:  Re: Need an inspection port lid for my Hobie 16, 5" port
You can get inspection ports from any Hobie Dealer - ships out daily. toll free 1800hobie49

They cost $10.89
Author:  buxton [ Tue May 08, 2012 2:26 pm ]
Post subject:  Re: Need an inspection port lid for my Hobie 16, 5" port
I know I have something at home, I'll check tonight, pretty sure is a 5" and not the 6. If so, it's new, but I won't be using it so can give to a real good deal
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/