| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| what constitutes a soft spot? http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=4381 |
Page 1 of 1 |
| Author: | BrianLaural [ Mon Jul 31, 2006 6:38 am ] |
| Post subject: | what constitutes a soft spot? |
I was going over my hulls and one hull is a bit softer that the other. One is solid with no give and the other when you push down with your thumb has the slightest give. A few milimeters at most in an area the size of my hand. It's right in front of the front pylon so I'm afraid it is the start of a soft spot. How soft does it need to be before a repair is needed? Should I address it now while it is small and easier to fix? Thanks |
|
| Author: | mmiller [ Mon Jul 31, 2006 4:21 pm ] |
| Post subject: | Small Delamination |
It may be difficult to get resin in the small area. It also may be an area that is simply crushed a bit. I suppose it is woth a shot if you can get it stopped now. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|