| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Mast step link kit drill bit question. http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=51151 |
Page 1 of 1 |
| Author: | paragon1970 [ Fri May 02, 2014 3:45 pm ] |
| Post subject: | Mast step link kit drill bit question. |
Hi Folks, I have just received my H14 / H16 mast step link kit from Hobie Center UK and it appears I will need to drill a hole for the link pin on both my H16 mast(s) I have two and the H14 mast base. The instructions state to use a 6.3mm drill bit, this is an unusual size of which I do not have. I do have in my possession a 6mm and a 6.5mm HSS drill bit, do you think it would be adequate to use the 6.5mm or could I expect some issue by doing so? I ask as this is the first time I will be attempting this procedure. Thanks SRG |
|
| Author: | AntonLargiader [ Fri May 02, 2014 4:38 pm ] |
| Post subject: | Re: Mast step link kit drill bit question. |
I bet they said 6.3mm because it's 1/4". Not that precise. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|