| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Comp Tip Mast Hardware http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=52145 |
Page 1 of 1 |
| Author: | Bill22405 [ Mon Jul 14, 2014 4:44 am ] |
| Post subject: | Comp Tip Mast Hardware |
I have a Hobie 16 with a comptip mast. One of the screws that hold the comp tip portion of the mast to the main is broken off inside the mast. When I attempted to remove with easy out the internal rod turns. It eventually pushed out of the other side. What I need is a replacement stainless steel sleeve. It is 5/16" diameter, 2 3/4" long, threaded 10-24. Any suggestions on where to purchase this? |
|
| Author: | sxrracer [ Mon Jul 14, 2014 1:00 pm ] |
| Post subject: | Re: Comp Tip Mast Hardware |
Contact a Hobie Dealer. |
|
| Author: | Bill22405 [ Mon Jul 14, 2014 1:05 pm ] |
| Post subject: | Re: Comp Tip Mast Hardware |
Thanks...Murrays advised that the part is no longer available. Heading to the machine shop..$40.00 |
|
| Author: | mmiller [ Mon Jul 14, 2014 3:13 pm ] |
| Post subject: | Re: Comp Tip Mast Hardware |
Bondo and a couple rivets. What you have is a VERY old CompTip of the first vintage. Current ones are held in by Epoxy and the and rivets. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|