| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Easily Removable Bob http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=56674 |
Page 1 of 1 |
| Author: | BboySlug [ Sat Jan 02, 2016 8:35 pm ] |
| Post subject: | Easily Removable Bob |
Although I've already decided to seal my mast for racing, alot of you guys provided good information in my previous post. Since I currently have the baby-bob on there, I would like to be able to use it in case I capsize when I eventually go dip it in salt water to guarantee that it don't turtle. I was thinking there is probably a way to take the Bob and make a custom connection so it's easy to remove and attach. That way, I can take it off for racing, and reinstall it easily for cruising. Have any of you already done something similar? If not, any ideas how I might get started with this engineering project? I have a comp-tip mast. The top of the mast has this pulley: http://www.murrays.com/50-20614001.html Thanks! -Evan |
|
| Author: | dorienc [ Sun Jan 03, 2016 1:12 pm ] |
| Post subject: | Re: Easily Removable Bob |
I take mine off for trailering every time I use it. There are two screws and nuts holding it on. Only takes a couple of minutes to put on or take off. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|