Hobie Forums
http://www.hobie.com/au/en/forums/

Mast pulley replacement - how to use rivet caps?
http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=59052		 Page 1 of 1
Author:  pulssarman [ Thu Sep 08, 2016 4:14 pm ]
Post subject:  Mast pulley replacement - how to use rivet caps?
I have the following parts, but need a sanity check to see if this is the right method to go about this;

Image

Now does the rivet, go into the cap;
Image

And then whole shebang goes into the part (and into the mast), and then riveted into place? Do I need to put any silicone or anything in/under anything?
Image

This is a shot of the bad part;
Image

Thanks!! Or maybe does the cap go in the mast first, then part, then rivet? *shakes head* :oops:

-Lyle
Author:  MBounds [ Thu Sep 08, 2016 7:29 pm ]
Post subject:  Re: Mast pulley replacement - how to use rivet caps?
You've got it right in the first series of photos.

But it really doesn't make any significant difference.

Rather than silicone, use a bit of Tef-Gel (http://www.westmarine.com/buy/tef-gel-- ... P012222212) to minimize galvanic corrosion between the rivet/rivet cap and the mast.
Author:  pulssarman [ Fri Sep 09, 2016 10:34 am ]
Post subject:  Re: Mast pulley replacement - how to use rivet caps?
Thanks for verifying my plan of attack! I'll see about getting some of that gel before I start. Thanks!
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/