| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| jib traveler trim kit question http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=5931 |
Page 1 of 1 |
| Author: | Misfit [ Mon Jan 22, 2007 12:51 pm ] |
| Post subject: | jib traveler trim kit question |
I am going to upgrade my boat at some point to have the jib traveler kit but wasn't planning on it right now. Currently, I have all of my corner castings removed from my boat and was wondering, does the Harken 40 mm Carbo Cheek on each corner casting thru bolt to the casting, rivited in place, or will I need to tap out threads on my corner casting? If it's thru bolted I think I should at least instal the cheeks to the casting b4 reassembling my boat. Thanks, Cory |
|
| Author: | sunjammers [ Mon Jan 22, 2007 1:43 pm ] |
| Post subject: | |
rivets work fine, no need to thru bolt. |
|
| Author: | hobie1616 [ Mon Jan 22, 2007 6:50 pm ] |
| Post subject: | |
There won't be a lot of shear stress on the cheek blocks so rivets will work just dandy. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|