You can order at the H14 length. The ends are milled to remove the tramp track... to fit into the corner castings, so just trimming the ends will not do it.
10191910 XBAR H14 AFT W/O CAST BK (INTEGRATED TRACK)
z181.jpg)
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Hobie 16 new style integrated rear beams used on H14 http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=61934 |
Page 1 of 1 |
| Author: | bob59 [ Mon Dec 18, 2017 7:51 pm ] |
| Post subject: | Hobie 16 new style integrated rear beams used on H14 |
Does anybody know if this will work. I think you can trim a few inches off to make it fit. |
|
| Author: | mmiller [ Tue Dec 19, 2017 8:27 am ] |
| Post subject: | Re: Hobie 16 new style integrated rear beams used on H14 |
You can order at the H14 length. The ends are milled to remove the tramp track... to fit into the corner castings, so just trimming the ends will not do it. 10191910 XBAR H14 AFT W/O CAST BK (INTEGRATED TRACK)
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|