Is it the hole for tying off the bungee on the Hobie 20 style tiller connectors?
sm
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Holes in tiller arm? http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=62880 |
Page 1 of 1 |
| Author: | dannybten23 [ Sun Jun 03, 2018 8:33 pm ] |
| Post subject: | Holes in tiller arm? |
I just got a new tiller arm for my H16. Why are there two sets oh holes? The holes are too far from the end to be for the end cap. One of the holes is covered by the upper rudder casting, one isn’t. Does it matter which side is into the casting and which is attached to the tiller? |
|
| Author: | srm [ Mon Jun 04, 2018 9:25 am ] |
| Post subject: | Re: Holes in tiller arm? |
Is it the hole for tying off the bungee on the Hobie 20 style tiller connectors? sm |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|