| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Early Epo's from 14 turbo http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=64731 |
Page 1 of 1 |
| Author: | A1cnc [ Mon May 20, 2019 5:04 am ] |
| Post subject: | Early Epo's from 14 turbo |
Hi Gang, I hope you all have wet your hulls this season! I have a 14 turbo with a set of early epo's and adjustable castings. My 16 has the white fiberglass I think rudders and non rake adjustable castings . Do any of you know if I could drill the epo's to work on both boats safely or would the holes be too close? I have not seen the drilling template or that might tell me everything I need to know. TIA, Eric |
|
| Author: | srm [ Mon May 20, 2019 2:52 pm ] |
| Post subject: | Re: Early Epo's from 14 turbo |
The 16 and 14 both use the same rudder castings, however the holes for the adjustable vs. non-adjustable castings are different. https://static.hobiecat.com/digital_assets/rudderdrill_FLvr0li.pdf?_ga=2.211142096.478254556.1556579139-2029119106.1505777923 sm |
|
| Author: | Tom King [ Mon May 20, 2019 4:12 pm ] |
| Post subject: | Re: Early Epo's from 14 turbo |
Just swap the whole rudder assemblies. |
|
| Author: | A1cnc [ Mon May 20, 2019 5:18 pm ] |
| Post subject: | Re: Early Epo's from 14 turbo |
Good to know that they use the same castings. I have epo's for my 16 now! I will just have to adjust the toe probably and maybe the rake we will see. Thank you guys for the replies Eric |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|