| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| H16 shroud adjuster clevis pin in top hole? http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=65079 |
Page 1 of 1 |
| Author: | ccowens [ Wed Jul 03, 2019 1:42 pm ] |
| Post subject: | H16 shroud adjuster clevis pin in top hole? |
On a H16, is there supposed to always be a clevis pin in the top hole of the shroud adjuster? It seems that, on the one hand this would help keep the side plates from spreading and keep the whole assembly stronger, but, on the other hand, if, say, the shroud eyelet is pinned in the third hole, the pin in the top hole kind of gets in the way and the lead is no longer straight and fair and true.... |
|
| Author: | mmiller [ Wed Jul 03, 2019 3:37 pm ] |
| Post subject: | Re: H16 shroud adjuster clevis pin in top hole? |
No. No pin above the pinned thimble. |
|
| Author: | ccowens [ Wed Jul 03, 2019 6:10 pm ] |
| Post subject: | Re: H16 shroud adjuster clevis pin in top hole? |
Thanks for the prompt and informative response! So much for being on vacation, eh? |
|
| Author: | mmiller [ Tue Jul 23, 2019 9:17 am ] |
| Post subject: | Re: H16 shroud adjuster clevis pin in top hole? |
That was the last day in! Great vacation! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|