Return to Hobie.com
Hobie Forums
It is currently Fri Nov 22, 2019 1:01 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Die cast Gudgeon
PostPosted: Thu Aug 22, 2019 10:39 am 
Offline
Site Rank - Deck Hand

Joined: Thu Sep 17, 2015 9:47 am
Posts: 3
I have a 96' hobie 16. It has the the 2 pc stainless brackets on the stern to attach the rudder to. I am doing a refurb on my boat this fall and was hoping to replace these brackets with the newer 1 pc Gudgeon's. Are the bolting hole patterns the same on the 1pc ones as the 2 pc brackets? ie, I dont need to redrill any new holes in the stern of the boat?? If so, is the the whole stern reinforced so I can just drill and set new fastneners with the new Gudgeons??

thanks.


Top
 Profile  
 
 Post subject: Re: Die cast Gudgeon
PostPosted: Thu Aug 22, 2019 5:42 pm 
Offline
Site Rank - Old Salt

Joined: Sun Sep 20, 2009 4:00 pm
Posts: 527
Location: Charlottesville, VA
Search the H16 section for "cast gudgeon" and you will get lots of good info. I did this within the last few days. From memory, four of the holes line up and the other two are optional, but read for yourself.

_________________
'00 H16 #104691
'78 H16 #32692 ex-rental [gone]
Old Holsclaw trailer
My Hobie 16 pages


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group