Hobie Forums http://www.hobie.com/au/en/forums/ |
|
Die cast Gudgeon http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=65415 |
Page 1 of 1 |
Author: | wasman [ Thu Aug 22, 2019 10:39 am ] |
Post subject: | Die cast Gudgeon |
I have a 96' hobie 16. It has the the 2 pc stainless brackets on the stern to attach the rudder to. I am doing a refurb on my boat this fall and was hoping to replace these brackets with the newer 1 pc Gudgeon's. Are the bolting hole patterns the same on the 1pc ones as the 2 pc brackets? ie, I dont need to redrill any new holes in the stern of the boat?? If so, is the the whole stern reinforced so I can just drill and set new fastneners with the new Gudgeons?? thanks. |
Author: | AntonLargiader [ Thu Aug 22, 2019 5:42 pm ] |
Post subject: | Re: Die cast Gudgeon |
Search the H16 section for "cast gudgeon" and you will get lots of good info. I did this within the last few days. From memory, four of the holes line up and the other two are optional, but read for yourself. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |