Hobie Forums

Die cast Gudgeon
Page 1 of 1

Author:  wasman [ Thu Aug 22, 2019 10:39 am ]
Post subject:  Die cast Gudgeon

I have a 96' hobie 16. It has the the 2 pc stainless brackets on the stern to attach the rudder to. I am doing a refurb on my boat this fall and was hoping to replace these brackets with the newer 1 pc Gudgeon's. Are the bolting hole patterns the same on the 1pc ones as the 2 pc brackets? ie, I dont need to redrill any new holes in the stern of the boat?? If so, is the the whole stern reinforced so I can just drill and set new fastneners with the new Gudgeons??


Author:  AntonLargiader [ Thu Aug 22, 2019 5:42 pm ]
Post subject:  Re: Die cast Gudgeon

Search the H16 section for "cast gudgeon" and you will get lots of good info. I did this within the last few days. From memory, four of the holes line up and the other two are optional, but read for yourself.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group