| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| H16 France Rudder Assumbly - Delrin Screws http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=66636 |
Page 1 of 1 |
| Author: | drej [ Tue Jun 02, 2020 9:56 am ] |
| Post subject: | H16 France Rudder Assumbly - Delrin Screws |
So....I have a 2001 H16 built in France. No surprise, but over the years, I have found a few differences between this boat and previous Hobie 16s I have owned. So...a couple of questions on rudder assembly parts?
And if so...does anyone know how I could grab a spare or two? Thanks! Andrej |
|
| Author: | Josefk [ Thu Jun 04, 2020 6:18 am ] |
| Post subject: | Re: H16 France Rudder Assumbly - Delrin Screws |
Yes you are correct, metric threaded, I found out the opposite way when I bought some spares for my 16 when I was back in the UK. My boat here in Japan is a US build and no dice with the screws when I got back. You can order the correct ones for your boat from one of the Hobie suppliers in Europe/UK. |
|
| Author: | mmiller [ Thu Jun 04, 2020 9:52 am ] |
| Post subject: | Re: H16 France Rudder Assumbly - Delrin Screws |
Should be the same as the early Tiger cam screw. In the US as: F99220006 TIGER CAM TENSION SCREW |
|
| Author: | drej [ Thu Jun 04, 2020 5:54 pm ] |
| Post subject: | Re: H16 France Rudder Assumbly - Delrin Screws |
Thank you, Josef and Matt. Appreciate the responses!! I will check with my local dealer for the Tiger part or else, I did find a dealer in France that I could try to contact. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|