| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Non-Comp Tip http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=67096 |
Page 1 of 1 |
| Author: | Jasonhavasu [ Sun Aug 02, 2020 10:40 am ] |
| Post subject: | Non-Comp Tip |
Hi all, I've found the non comp tip mast to be superior in every way to the comp tip so much that I have purchased old masts just to keep the boat going strong. I have one issue that I'm afraid I may already know the answer too, but thought I would throw it out anyway. In the parts catalogue, I can't find the 16 non-comp tip, but I can find halyards etc. I have found many used on eBay, but I'm hoping for a new old stock non comp masthead tip. If anyone has a bead on one. I'd appreciate it! |
|
| Author: | chevy43 [ Tue Aug 11, 2020 12:06 pm ] |
| Post subject: | Re: Non-Comp Tip |
As far as I can tell the only thing that goes bad is the plastic pulley. I'm going to make a new one on the lathe at some point. |
|
| Author: | srm [ Tue Aug 11, 2020 2:07 pm ] |
| Post subject: | Re: Non-Comp Tip |
I’m pretty sure that the comptip mast head can also be installed on the all-aluminum mast by drilling some holes for the fasteners in the appropriate locations. sm |
|
| Author: | mmiller [ Tue Aug 11, 2020 3:37 pm ] |
| Post subject: | Re: Non-Comp Tip |
Plus the CompTip halyard. Yes that would work. |
|
| Author: | CaptObviousNC [ Thu Aug 13, 2020 6:15 pm ] |
| Post subject: | Re: Non-Comp Tip |
My old non comp sheave finally gave up the ghost. Made a new one with nylon, stainless sheet, and epoxy. So far so good but a lathe would have been handy!! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|