I am upgrading my jib sytem to new Ronstan jib cars. Does anyone have a recommendation on how to keep the pin up on these so I can adjust them with my barberhauler lines? I'd hate to have to grind the pins off these brand new parts
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Ronstan jib cars http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=6722 |
Page 1 of 1 |
| Author: | mattnd54 [ Sun May 13, 2007 10:29 am ] |
| Post subject: | Ronstan jib cars |
I am upgrading my jib sytem to new Ronstan jib cars. Does anyone have a recommendation on how to keep the pin up on these so I can adjust them with my barberhauler lines? I'd hate to have to grind the pins off these brand new parts
|
|
| Author: | Karl Brogger [ Sun May 13, 2007 11:00 am ] |
| Post subject: | |
I tied the adjustment line around the pin. Pull the pin up and tie it tightly. I only had a problem a couple of times in two years set up like this. You might be able to put a zip-tie around the pin to hold it up also. That would pretty much guarantee the pin wouldn't go back down. |
|
| Author: | sunjammers [ Mon May 14, 2007 8:45 am ] |
| Post subject: | |
yea the line should keep the pin up no problem. I do like the idea of the zip tie! |
|
| Author: | Fender [ Mon May 21, 2007 5:19 am ] |
| Post subject: | |
I did the same upgrade and what the instructions say is to tie a figure 8 know around the pin. I did it like that and it hold the pin up no problem. You are gonna love the new set up. It makes alot of difference! 
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|