| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Harken H194 replacement screws question http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=67630 |
Page 1 of 1 |
| Author: | Dookie [ Mon Nov 16, 2020 8:41 am ] |
| Post subject: | Harken H194 replacement screws question |
Hobie Team: I have the H194 block and the screws/locknuts holding the cam cleat bracket to the block body need to be replaced. Does anyone have some guidance on where to get these parts? Harken's website doesn't seem to offer these as spare/replacement parts. Thanks! Daniel |
|
| Author: | srm [ Mon Nov 16, 2020 10:53 am ] |
| Post subject: | Re: Harken H194 replacement screws question |
They should be size 10-24 screws, which is a standard size. You can start by checking your local Home Depot/ hardware store. As long as they have the correct length in stainless steel, that should be fine. If not, you can always order from McMaster Carr (industrial warehouse), but you will have to order more than you need since they generally don’t sell in small quantities. sm |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|