| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Hull shape http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=68414 |
Page 1 of 1 |
| Author: | MRawlings [ Mon May 31, 2021 5:43 pm ] |
| Post subject: | Hull shape |
Hi Guys Im doing a bottom job on my H16 I Have found that template that is out there but if I follow that the keel would come to a point all the way along, is this correct as mine has about a 2inch flat section along the middle section, or has mine just wore that much? |
|
| Author: | mmiller [ Tue Jun 01, 2021 11:40 am ] |
| Post subject: | Re: Hull shape |
Yes... worn flat. |
|
| Author: | MRawlings [ Tue Jun 01, 2021 3:12 pm ] |
| Post subject: | Re: Hull shape |
So they come to a sharp edge all the way along? as i found out last night as removing an old repair job it has worn all the way though on both hulls. |
|
| Author: | mmiller [ Tue Jun 01, 2021 5:12 pm ] |
| Post subject: | Re: Hull shape |
The template would be the guide. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|