| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Old mast step - new mast base compatability http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=68588 |
Page 1 of 1 |
| Author: | Waiex191 [ Mon Jun 28, 2021 7:52 am ] |
| Post subject: | Old mast step - new mast base compatability |
Hi all, Hoping for a good answer from the forum for my question. I have an old '77 H16 and the mast base is cracked at the hole where the step hinge goes. Not all the way, but I'd like to replace it for mast stepping safety. If I buy a new Hobie mast base will it be compatible with my old mast step? Many thanks, |
|
| Author: | Robie Hobie [ Fri Jul 02, 2021 3:15 am ] |
| Post subject: | Re: Old mast step - new mast base compatability |
I don't think a '77 is much different from my '85 H16. Just replaced the original mast base, and not the mast step, with a new one without any issues of mast rotating. I've heard that sometimes the older mast steps don't always match up well with newer mast bases because Hobie has increased the mast rake over the years a couple of times. This could cause the two to bind where the casting for the pin hits the step, possibly keeping the mast from rotating while sailing. Hope this helps some... |
|
| Author: | Waiex191 [ Fri Jul 02, 2021 7:49 am ] |
| Post subject: | Re: Old mast step - new mast base compatability |
Thanks Robie! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|