| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Resealing rudder/plug hardware http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=6970 |
Page 1 of 1 |
| Author: | SpecialEd [ Sat Jun 09, 2007 11:09 pm ] |
| Post subject: | Resealing rudder/plug hardware |
Do I need to take these out and out in a gasket or something or just scrub off the old goop and put some under the waterline sealant on it?[img] how do you put pictures in here? |
|
| Author: | Skipshot [ Sat Jun 09, 2007 11:28 pm ] |
| Post subject: | |
Could you be a little bit more vague? I'm not sure I don't understand your question. |
|
| Author: | syphon [ Sun Jun 10, 2007 4:12 pm ] |
| Post subject: | |
I haven't seen any gaskets, but on my boat i took the entire piece out and then used some under water line gasket schmoo and just applied a nice layer all the edge of the hole and stuff. I also used good solid bunch of wraps around the drain plug with teflon tape. I really don't know if my fixup will work well because I haven't put it in the water yet, but I hope it does. |
|
| Author: | SpecialEd [ Sun Jun 10, 2007 9:18 pm ] |
| Post subject: | |
Sorry Admiral thats why I asked how to put pictures in here. |
|
| Author: | Doc Thirst [ Mon Jun 11, 2007 6:06 am ] |
| Post subject: | |
Not your fault you're special. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|