| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| How much Git Rot? http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=7076 |
Page 1 of 1 |
| Author: | Gdbyrd [ Thu Jun 21, 2007 10:01 pm ] |
| Post subject: | How much Git Rot? |
There's a large soft spot on the starboard ahead of the pylon..and about a foot in front of the rudder on the same side. It's large, about a foot in front of the pylon..it goes from there up to about 2 feet from the bow. How much Git Rot will I need to order to fill this large of an area. Why is it always the right side that seems to be affected? From what I've been reading it seems like that's always the side that's getting the soft spots.... Thank you in advance. |
|
| Author: | mmiller [ Fri Jun 22, 2007 11:24 am ] |
| Post subject: | How much |
Not always the right side... Maybe regional as one side may be the side people most often climb on and off due to wind direction. Two small 4 oz bottles of Git Rot should do it as long as you limit the pressure when squirting into the deck. The delamination is paper thin in most cases. More pressure just forces the layers apart. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|