| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Tiller Cross bar distance from tramp? http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=7340 |
Page 1 of 1 |
| Author: | beeryboats [ Thu Jul 19, 2007 5:13 pm ] |
| Post subject: | Tiller Cross bar distance from tramp? |
Last weekend was the maiden on my rebuilt H16. My last Hobie was ten years ago. The tiller cross bar seemed way far away from the tramp when the rudders were down. I just don't remember if this is normal. They seemed locked down, I did replace the cams and buttons. Seems like the cross bar was about 18" aft of the tramp and slightly higher. Jay |
|
| Author: | mdgann [ Fri Jul 20, 2007 2:47 pm ] |
| Post subject: | crossbar distance |
Berry, That sounds about right. |
|
| Author: | mmiller [ Fri Jul 20, 2007 3:45 pm ] |
| Post subject: | Just guessing |
18" aft of the crossbar is a bit far. There is no spec, but I think it is closer to 6-10" aft (at most) of the crossbar when the rudders are down. |
|
| Author: | beeryboats [ Fri Jul 20, 2007 3:52 pm ] |
| Post subject: | |
Hmmmm. Sounds like I better get the boat in deep water and play with the down locks. I seem to remember the bar level and about six-eight inches behind the tramp frame. Jay |
|
| Author: | mmiller [ Fri Jul 20, 2007 3:58 pm ] |
| Post subject: | xbar |
Rebuilt boat? Maybe it has Hobie 14 tiller arms? |
|
| Author: | beeryboats [ Fri Jul 20, 2007 7:39 pm ] |
| Post subject: | |
That could be! But I doubt it. What is the difference in length? |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|