| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Post Epoxy Question http://www.hobie.com/au/en/forums/viewtopic.php?f=14&t=9239 |
Page 1 of 1 |
| Author: | Cayuga [ Mon Apr 28, 2008 5:58 am ] |
| Post subject: | Post Epoxy Question |
I bonded my '82 together over the weekend, very pleased with the early results. However one thing I did notice after everything cured... The port hull/rudder pin is out of plumb by 3-5 degrees. Although the castings were loose, I don't believe there was enough to cheat the hull. So my question is; is this by design or flaw? |
|
| Author: | MBounds [ Mon Apr 28, 2008 8:46 am ] |
| Post subject: | |
Could have happened when the lower gudgeon was mounted 26 years ago. Wouldn't take much of an offset to generate that little angle. I wouldn't worry about it. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|