I discovered some pin holes on the seam of the my outback hull (see attached photos). Has anybody else discovered these, if so is it a cause for concern?
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Pin Holes http://www.hobie.com/au/en/forums/viewtopic.php?f=140&t=64659 |
Page 1 of 1 |
| Author: | YakinEngineer [ Tue May 07, 2019 1:11 pm ] |
| Post subject: | Pin Holes |
I discovered some pin holes on the seam of the my outback hull (see attached photos). Has anybody else discovered these, if so is it a cause for concern?
|
|
| Author: | mmiller [ Tue May 07, 2019 3:55 pm ] |
| Post subject: | Re: Pin Holes |
That is along the mold parting line and is due to heat escaping during molding, but these are not pin holes. These are exposed tiny bubbles in the plastic that do not go thorough to the inside. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|