| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Rivets on hull of outback http://www.hobie.com/au/en/forums/viewtopic.php?f=140&t=64758 |
Page 1 of 1 |
| Author: | Shawn [ Fri May 24, 2019 2:38 pm ] |
| Post subject: | Rivets on hull of outback |
On the hull of 2019 outback right at front of mirage inset hole. There is what appears to be a brass river or brass bolt. It appears to have pulled INTO the plastic of the hull exposing a small gap. Is this normal? What should I do? |
|
| Author: | mmiller [ Tue May 28, 2019 2:55 pm ] |
| Post subject: | Re: Rivets on hull of outback |
Normal. This fitting is designed to draw more material to the area during molding. There should be a small cap on it for cosmetic reasons only. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|