| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| 2019 Outback scupper sleeve anomaly http://www.hobie.com/au/en/forums/viewtopic.php?f=140&t=65388 |
Page 1 of 1 |
| Author: | netfl0 [ Fri Aug 16, 2019 11:45 am ] |
| Post subject: | 2019 Outback scupper sleeve anomaly |
Hobie, I noticed that the black scupper sleeves are not symmetrically inserted into the scupper holes. The starboard sleeves protrude from the bottom of the hull more than the port sleeves. They also do not appear to be seated at the top of the scupper "collar" Will this cause problems? Good:  Less Good: 
|
|
| Author: | mmiller [ Mon Aug 19, 2019 5:31 pm ] |
| Post subject: | Re: 2019 Outback scupper sleeve anomaly |
Likely would not turn one more half-turn without bottoming out. They have to stop with the oval shape facing side to side, as these are. Not a problem. |
|
| Author: | netfl0 [ Tue Aug 20, 2019 5:06 am ] |
| Post subject: | Re: 2019 Outback scupper sleeve anomaly |
mmiller wrote: Likely would not turn one more half-turn without bottoming out. They have to stop with the oval shape facing side to side, as these are. Not a problem. Thanks Matt Sent from my iPhone using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|