| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Garmin transducers http://www.hobie.com/au/en/forums/viewtopic.php?f=140&t=65625 |
Page 1 of 1 |
| Author: | rotorhead92 [ Wed Oct 02, 2019 3:16 pm ] |
| Post subject: | Garmin transducers |
I checked the Hobie templates for transducers, but there wasn't any information for Garmins. I'm thinking of getting an Outback and was wondering if I could install the garmin GT51(sideview) or GT23 transom transducers? |
|
| Author: | Tom Kirkman [ Wed Oct 02, 2019 6:31 pm ] |
| Post subject: | Re: Garmin transducers |
Not sure if the transducers are the same, but I mounted a Garmin Echo transducer to the Hobie AI/TI Lowrance plate with ease. Cut one of the plastic uprights and fastened the transducer to the plate with two plastic wire tires. Very clean and very effective. Not sure how to post photos here, however. If you can't figure it out, send me a private message and I'll get you some photos by email. |
|
| Author: | rotorhead92 [ Thu Oct 03, 2019 10:32 am ] |
| Post subject: | Re: Garmin transducers |
thanks, |
|
| Author: | pdxfisher [ Mon Oct 07, 2019 9:36 am ] |
| Post subject: | Re: Garmin transducers |
I made my own for my GT50-TM by taping some paper to the transducer and then poking holes where the screw holes were. It seemed to work well and was not too hard to do. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|