Hobie Forums
http://www.hobie.com/au/en/forums/

banjo bolt and socket nut for Vantage seat
http://www.hobie.com/au/en/forums/viewtopic.php?f=140&t=68918		 Page 1 of 1
Author:  Duncan49 [ Thu Aug 19, 2021 9:59 am ]
Post subject:  banjo bolt and socket nut for Vantage seat
What is the part number and size for the socket nut which holds the banjo bolt that keeps tension on the rod that holds the upper mesh of the Vantage seat?
Author:  mmiller [ Thu Aug 19, 2021 2:29 pm ]
Post subject:  Re: banjo bolt and socket nut for Vantage seat
Are you referring to the lumbar support system? Photo maybe?
Author:  Duncan49 [ Thu Aug 19, 2021 3:53 pm ]
Post subject:  Re: banjo bolt and socket nut for Vantage seat
I replaced the mesh back. The two full length spring rods that holds the mesh on each side are attached to the back frame with banjo bolts and barrel-sleeve nuts, one on each side. When I removed the nut it was stripped, overtightened from the original assembly probably, and now won't hold. On the back of the seat there are two phillips screws. These are not really screws but the nuts I'm speaking of.
Author:  mmiller [ Fri Aug 20, 2021 9:14 am ]
Post subject:  Re: banjo bolt and socket nut for Vantage seat
865090 BARREL SCREW

Image
Author:  Duncan49 [ Fri Aug 20, 2021 9:52 am ]
Post subject:  Re: banjo bolt and socket nut for Vantage seat
That's it, thanks.
Author:  Duncan49 [ Sat Aug 21, 2021 8:39 am ]
Post subject:  Re: banjo bolt and socket nut for Vantage seat
Matt, I'm having a hard time locating this part. I think no one stocks it because it is a non wear part. May I email you for some help?
Author:  mmiller [ Tue Aug 24, 2021 4:44 pm ]
Post subject:  Re: banjo bolt and socket nut for Vantage seat
Any dealer can order this. They would not stock it.
Author:  Duncan49 [ Fri Aug 27, 2021 8:42 am ]
Post subject:  Re: banjo bolt and socket nut for Vantage seat
Thanks, I did find one.
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/