| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Cut Hole Too Big - Uh Oh! http://www.hobie.com/au/en/forums/viewtopic.php?f=142&t=68598 |
Page 1 of 1 |
| Author: | michael.anderson [ Tue Jun 29, 2021 2:44 pm ] |
| Post subject: | Cut Hole Too Big - Uh Oh! |
I have a 2021 Hobie Passport 12. I was trying to convert the round hatch in front of the seat to the rectangle hatch. I measured wrong and cut the hole too big. I have the piece I cut off, as it is in one piece. Would like ideas as to how to somehow correct so the rectangle hatch can be screwed into something secure. I was thinking maybe a piece of PVC "wood" in the hole but am unsure how to secure it onto the kayak. Any of your creative ideas are certainly welcome! |
|
| Author: | mrpj1972 [ Thu Jul 01, 2021 7:22 am ] |
| Post subject: | Re: Cut Hole Too Big - Uh Oh! |
Sounds like you need to cut a flange piece out of some Starboard material. If you're not familiar, Click here Unfortunately, it will sit higher than planned but it will get you back on the water. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|