Hobie Forums http://www.hobie.com/au/en/forums/ |
|
Power pole insert screw size http://www.hobie.com/au/en/forums/viewtopic.php?f=146&t=68500 |
Page 1 of 1 |
Author: | [email protected] [ Mon Jun 14, 2021 6:33 am ] |
Post subject: | Power pole insert screw size |
Does anyone know the proper screw size to use to mount a power pole bracket to the inserts in the board? |
Author: | mmiller [ Tue Jun 22, 2021 5:20 pm ] |
Post subject: | Re: Power pole insert screw size |
SCREW #14 x ¾ PHSMS-PH |
Author: | Special K [ Tue Sep 21, 2021 9:48 am ] |
Post subject: | Re: Power pole insert screw size |
Are all the screw sizes on the Lynx the same as the power pole mount screws size? |
Author: | mmiller [ Tue Sep 21, 2021 4:28 pm ] |
Post subject: | Re: Power pole insert screw size |
Showing two screws for the Lynx Screw #14 X 3/4” PHSMS 8031891 Screw #8 x 1” FHSMS 8031511 |
Author: | Special K [ Wed Sep 22, 2021 2:44 pm ] |
Post subject: | Re: Power pole insert screw size |
Thank You!! |
Author: | smatthew [ Wed Sep 22, 2021 5:13 pm ] |
Post subject: | Re: Power pole insert screw size |
Does this mean the power pole insert is shipping? |
Author: | mmiller [ Wed Sep 22, 2021 5:29 pm ] |
Post subject: | Re: Power pole insert screw size |
Yes! A bunch shipped in mid-to-late August. No back orders. |
Author: | Maxfli [ Fri Mar 29, 2024 11:30 am ] |
Post subject: | Re: Power pole insert screw size |
Installed Power Pole Micro using the 3/4” screw. It pulled out first time I tried to use. What is maximum length that can be used? Can I supplement with locktite lot silicone? |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |