This is my beta version, after the holidays I will be ready with Release candidate.
The plates are from anodized aluminum.
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Hobie Lynx - Anchor System, no drilling, no holes! http://www.hobie.com/au/en/forums/viewtopic.php?f=146&t=69351 |
Page 1 of 1 |
| Author: | johnnybravo [ Fri Dec 17, 2021 1:59 pm ] |
| Post subject: | Hobie Lynx - Anchor System, no drilling, no holes! |
This is my beta version, after the holidays I will be ready with Release candidate. The plates are from anodized aluminum. |
|
| Author: | wdkerber [ Mon Dec 27, 2021 5:39 pm ] |
| Post subject: | Re: Hobie Lynx - Anchor System, no drilling, no holes! |
Looks good! I can't tell how the plates are attached to the hull. Are they glued on with epoxy? |
|
| Author: | johnnybravo [ Fri Jan 28, 2022 11:13 am ] |
| Post subject: | Re: Hobie Lynx - Anchor System, no drilling, no holes! |
3M Extreme. We did a few tests of the anchor system, pulled a lynx in cold water and created a very large constriction on the plates. Everything stayed in place and works perfectly. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|