Hobie Forums
http://www.hobie.com/au/en/forums/

A few ideas for attaching accessories to the Lynx seat.
http://www.hobie.com/au/en/forums/viewtopic.php?f=146&t=71332		 Page 1 of 1
Author:  johnnybravo [ Sun Mar 24, 2024 1:14 am ]
Post subject:  A few ideas for attaching accessories to the Lynx seat.
A few ideas for attaching accessories to the Lynx seat.

https://www.youtube.com/watch?v=o-NAdzbq2aE


For the installation of H-Rails, there is no need to drill additional holes on the seat, the existing holes are used, the front bolt goes to the back, because it is longer, and in the front I put a new even longer bolt with a length of 80mm.

Image
Image

I also converted the seat from the Hobie Passport to the Hobie Lynx because I mainly use the kayak in the sea and the low center of gravity gives me a lot of extra stability.

https://www.youtube.com/watch?v=4OmVBodv1IM


Image
Image
Image
Author:  johnnybravo [ Sun Mar 24, 2024 11:15 am ]
Post subject:  Re: A few ideas for attaching accessories to the Lynx seat.
Image
Image
Image
Image
Image
Image
Author:  johnnybravo [ Mon Mar 25, 2024 9:37 am ]
Post subject:  Re: A few ideas for attaching accessories to the Lynx seat.
Today I made another improvement - an extension for the (845044) HANDLE END FITTING, so it grips the seat tube very well.

Image
Image
Image
Image
Image
Image
Image
Image
Image
Author:  johnnybravo [ Tue Apr 02, 2024 11:16 pm ]
Post subject:  Re: A few ideas for attaching accessories to the Lynx seat.
https://youtube.com/shorts/hN3XcDNxSLk? ... iFP1yNi_CX
Author:  plfinch [ Wed Apr 03, 2024 10:34 am ]
Post subject:  Re: A few ideas for attaching accessories to the Lynx seat.
That's some clever fabricating - WOW!

Since the Hobie iTrek and Compass kayaks use the same seat assembly (Hobie part #87800000), this post applies to them as well. Much more applicable to the inflatable iTreks since hull drilling isn't in any way an option.

Do you intend to sell parts or make the 3DP models available?

Peter
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/