| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Lynx drive well moves http://www.hobie.com/au/en/forums/viewtopic.php?f=146&t=71901 |
Page 1 of 1 |
| Author: | Michole [ Wed Apr 30, 2025 10:56 am ] |
| Post subject: | Lynx drive well moves |
I took my 2024 Lynx out salmon fishing today on the Willamette River and I started to hear a knock like a stick was hitting the hull but after further investigation, I found the front part of the drive well is slightly loose and creates a knocking sound when pedaling slowly as I troll. I have used the 2024 about 10 times and I have a 2022 that I have used more than a 100 times without any issues. Has anyone else seen this or is there a way to tighten the drive well? |
|
| Author: | Dr.SteelheadCatcher [ Fri May 02, 2025 6:23 am ] |
| Post subject: | Re: Lynx drive well moves |
If you are referring to the click and go assembly, yes, you can tighten up the Allen head bolts, but need a round headed Allen wrench due to to the off angle needed to tighten it. |
|
| Author: | Michole [ Fri May 02, 2025 11:35 pm ] |
| Post subject: | Re: Lynx drive well moves |
Thanks for the replay but it is not the click-n-go assembly. I am talking about the entire oval insert that the drive sits in. The front portion is slightly loose and can move about 1/16 to 1/8 and there doesn’t seem to be a way to tighten it. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|