| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Rudder hole position http://www.hobie.com/au/en/forums/viewtopic.php?f=15&t=57688 |
Page 1 of 1 |
| Author: | Aussie7496 [ Tue May 17, 2016 8:58 pm ] |
| Post subject: | Rudder hole position |
I've found the template for drilling holes in rudders, but can anyone tell me if the hole position differs from the H20? The castings appear the same for the 17,18 and 20, but the guide does not have the 20 listed. Ultimately I have a 20 and am wondering if the blades will change over. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|